Cliffs TestPrep. Cisco CCNA 

1

• 1. Table of Contents

• 2. Back Cover

• 3. Cliffs TestPrep-Cisco CCNA

• 4. Part I: Introduction to the Cisco CCNA Exam

  Chapter List Part Overview

• 5. Questions Commonly Asked About the Cisco CCNA Exam

• 6. Analysis of the Exam

  Ability Tested

• 7. Basic Skills Necessary

  Basic Skills Necessary

• 8. Types of Questions You ll Find on the CCNA Exam

  Types of Questions You ll Find on the CCNA Exam The Multiple-Choice Format Simulations Drag and Drop

• 9. Test-Taking Tips

  Test-Taking Tips Suggested Approaches Best Practices for Prep

• 10. Part II: Full-Length Practice Tests

  Chapter List

• 11. CCNA-Practice Test 1

  You have two routers directly connected via a serial link. One of them is made by Cisco, the other is a different brand. Choose the command you would use on a Cisco router to create a WAN connection between these two routers. The Corporate router receives an IP packet with a source IP address of 192.168.214.20 and a destination address of 192.168.22.3. Looking at the output form the Corporate router, what will the router do with this packet

• 12. CCNA-Practice Test 2

  Look at the following diagram. From what you see there, which of the following switches will be elected root bridge, and why? Based on the following diagram, choose two options that describe ports that can safely be configured with PortFast: switchx (config)# interface fastethernet 0/1 switchx (config-if)#switchport mode trunk Look at the following diagram. From what you see there, which of the following switches will be elected root bridge, and why the server in vlan 4 offers the required resources to support the user host in other vlans. which interfaces are access ports

• 13. CCNA-Practice Test 3

  possible frame relay /30 subinterfaces for 172.1.0.0 Look at the following diagram. Assume that ports 1 through 3 are designated to VLAN1 and ports 4 through 6 are designated to VLAN2 on each switch. Further, assume that your switches connect via a trunk link. Pick the three events that confirm that both your VLAN and trunk are working correctly

• 14. CCNA-Practice Test 4

• 15. CCNA-Practice Test 5

  cisco ccna Has been integrated into a network and routing tables have been completed. A packet to be transmitted, the routing table is the first criteria used to determine the best way to Telnet connections and pings run from the command prompt determine how A network technician is asked to design a small network with redundancy. the exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design? Study Figure 15. The router has been configured to provide communication between theVLANs. Which IOS commands are required to configure switch port fa0/1 to establish alink with router A using the IEEE standard protocol? (Choose three.)

• 16. CCNA-Practice Test 6

• 17. CCNA-Practice Test 7

• 18. CCNA-Practice Test 8

• 19. CCNA-Practice Test 9

  Look at the following diagram. Switch SW-Seattle01 has recently been added to the network but has yet to get appropriate VLAN information from the VTP domain. What is causing this problem? (Choose two.) straight through cable network connection

• 20. CCNA-Practice Test 10

1